Reserved Listing For David

Reserved Listing For David

Flash board (70x40x15) with ten solder pin terminals & adjustable flash rate @ £9.99

Each of the ten terminals will flash up to three LEDs - with each requiring soldering in parallel to a single terminal.

If six LEDs are required, you would need to tag them to the next port along which would incur a minimal fraction of a second delay.

You would not need resistors for these six flashing LEDs connected to the board.

Polarity is marked on each terminal on the board, which should be matched to each LED wired individually in parallel.

This listing also includes a 9V battery box with built-in switch and micro screw terminal connector @ £2.49

There's a short video clip here that shows the board working with one LED and one filament.

This particular listing is for the board and the battery box unit only.

Extra items which you may need to add to the order:

Black AWG 30 Wire is listed here:

https://www.captainjacksmodels.co.uk/ourshop/prod_8006217-AWG-30-PVC-Insulated-Wire-BLACK-1-Metre.html

White AWG 30 Wire is listed here:

https://www.captainjacksmodels.co.uk/ourshop/prod_8006236-AWG-30-PVC-Insulated-Wire-WHITE-1-Metre.html

Remember to allow enough for each LED required plus the power lead wire from the battery box.

Heat shrink available in this section in case you need it:

https://www.captainjacksmodels.co.uk/ourshop/cat_1717828-Heat-Shrink-Tubing.html

---------

For the engine lighting, have a look at the flexible LED filament below. It is already fitted with a resistor - possibly the 110mm cool white may suit?:

https://www.captainjacksmodels.co.uk/ourshop/cat_1807814-LED-Filament.html

The other option is rigid filament, but this is fragile and requires a resistor:

https://www.captainjacksmodels.co.uk/ourshop/cat_1847055-LED-Filament-Rigid-COB.html

With either option you would need two filaments, again wired in parallel to the marked terminal that joins the battery box power wire to the board.

The remaining LEDs you should already have as per your email, but will need resistors for the 3mm landing lights (plus rigid filaments if opting for those) if you dont't have them. 470ohms will be fine and are listed here:

https://www.captainjacksmodels.co.uk/ourshop/prod_8300759-470-Ohm-High-Quality-Metal-Film-Resistor-025W.html

Link to additional four 3mm and twelve 2mm LEDs:

https://www.captainjacksmodels.co.uk/ourshop/prod_8379670-Reserved-Listing-Extra-LEDs.html